Start with the outbuildings on the plot
North of the village, Hertfordshire's landscape assessment of the Arkley Plain describes widely dispersed farmsteads, most of them modest in scale and some converted to riding stables, along with green lanes such as Arkley Lane.
Mark the main house, garages, detached accommodation and other structures on a plot plan. Explain which are occupied, locked or difficult to reach, and identify the access contact.
A plan prepared to sell a house seldom shows the offset from a proposed trench to a neighbouring stable wall. For an extension under the Party Wall etc. Act 1996, show the edge of excavation, the closest part of each adjoining structure and its foundation where known. Section 6 sets different tests within three metres and six metres. A large distance between the two front doors tells the designer little about a foundation close behind a garage. Include the drainage runs and any pad supporting a post as well as the main foundations.
For an outbuilding converted in stages, mark the parts that existed before the change of use. Is the nearest wall part of the original structure, an infill between earlier posts or an addition built later? Ask for photographs or a section from the conversion before adopting a construction detail from a new barn on a different plot. Record an unknown level as unknown so the engineer can decide what to investigate.
The wall between two building phases
For an enlarged Arkley house, collect available plans showing successive wings, roof rooms and converted garages. A single current plan may conceal differences in construction, floor level and roof form between phases.
If the new roof is to be carried on masonry shared with a neighbouring building, identify the cut for each bearing and the proposed support while it is being made. Rights under section 2 for particular work to a party structure are exercised through the party structure notice procedure in section 3. A freestanding frame which stays within the house may call for a different assessment. Where an entirely new wall is planned at the line of junction, locate its face and foundations separately for section 1.
If a particular crack, leak or recurring repair prompted the enquiry, provide its location and timeline. The surveyor can assess visible evidence without relying on an unsupported explanation linked to the area’s landscape.
What a ridge description can tell the designer
A London geodiversity site assessment, published in 2021, describes a Stanmore Gravel ridge around Arkley, with the Claygate Member shown beneath the gravel at about 125m. On the plain to the north, the Hertfordshire assessment records Tertiary clay overlaid by slowly permeable and seasonally waterlogged soils, with small streams rising on the impermeable clay. These are landscape-scale descriptions, not ground investigation of any plot.
A useful section for a garden excavation has one reference level for both plots. Give the designer photographs showing any change of level across the work and ask which levels have actually been established. A landscape map can explain why two published descriptions of Arkley differ. It cannot supply the depth of a particular footing or demonstrate the cause of a mark in a neighbour's wall.
For a pre-works schedule, agree access to the nearest face of the outbuilding and to its interior if appropriate. Locate the wall by an identifiable opening or corner, show the whole elevation and then record an individual crack or open joint. Note material stored against the wall, any lining that prevents inspection and the date of the visit. If access for a follow-up visit has to be arranged with a separate occupant, retain that contact with the record.
Barnet records and permission to enter
A large garden or open setting does not establish development potential. The landscape assessment is background evidence, not a permission or a technical feasibility study for your proposal.
Keep Barnet's decision on the particular proposal with its approved drawings. The construction issue may contain deeper foundations or a different route to the site. Compare those details before relying on a notice prepared at planning stage. An award addresses matters within the Act. Building control, any permission under a lease, and the terms for using land outside the statutory arrangements each need separate attention. Arrange the date, route and purpose of an inspection before anyone enters the neighbouring yard.
If the excavation appears close to your property
An Arkley adjoining owner can mark their workshop, stable or accommodation on the plan supplied with a notice. Give its approximate use, any previous foundation information and where the nearest wall can be seen. Keep the original papers and service date. Our party wall advice for adjoining owners explains the available responses and how to raise a missing building with the surveyor.
Arkley party wall questions
Can my neighbour’s detached workshop count for the excavation test?
The Act refers to adjoining buildings or structures. Identify the actual workshop position, the proposed dig and available evidence of its footing so the surveyor can test the relevant distances and levels.
Can the same photographs cover our original wing and later garage?
Take views that show where each structure begins and ends. Different construction dates or support details may matter later even where one continuous coat of render crosses the junction.
What should I send if the proposal changes from a slab to individual pads?
Send the revised foundation drawing with the depth and location of each pad, including any deeper local cut. Mark the superseded issue and ask the surveyor to reconsider the changed excavation before it starts.