Draw the upper line as well as the ground-floor line
A compact frontage can leave the back of a plot unexplained. The council-hosted character document is a consultation draft used here for historical building descriptions only.
The draft appraisal describes a core that grew from narrow burgage plots into a dense grain of modest buildings on small plots, which in most cases abut one another and often stand directly on the street. Many of the earliest buildings are timber-framed, the draft says, with many frames now infilled with brick noggin or knapped flint, and some timber framed buildings are jettied at first floor level. The draft names Bargate, a local sandstone, as the more widely used of the village's two local sandstones.
For a new opening inside a narrow-fronted house, identify which wall will be cut and what occupies the space immediately above it. A jetty or upper room may project beyond the ground-floor line on a survey drawing. Ask where both ends of the beam will bear and what temporary support the contractor intends to use. If part of the design cuts into a party structure, consider section 2 of the Party Wall etc. Act 1996 and the party structure notice under section 3. Historic appearance by itself does not establish ownership of the wall or the reach of a statutory right.
State whether the rear space is part of the same house, a separate unit or an external structure whose use needs clarification. The appointment should be discussed around that actual arrangement rather than an assumed age or form derived from the road frontage.
Identify any shared route or separately controlled part before relying on it for inspection access.
Excavations near a change in levels on Shere Lane
The draft’s Shere Lane account describes higher ground beside the road with retaining walls and hedges. A townscape description does not determine the inspection extent.
Identify any external structure, bank or enclosure you expect to be considered and the access available around it.
When one house stands above the proposed work, use one datum for the top and bottom of a bank, adjoining ground, any retaining structure and the bottom of the new excavation. For section 6, plot the distance to the adjoining building or structure and identify the basis of each neighbouring foundation level. A fence drawn at the top edge of the bank is not a reliable point from which to infer the depth beneath the adjoining house.
Where the new wall is proposed at the line of junction, check the section 1 position separately. Where a structure retains ground, the design may require specialist information about how it will be supported while work takes place. Give the surveyor the engineer's proposed method and identify any parts of the neighbour's land required for the operation. Agree arrangements for viewing the feature before works apart from any temporary occupation.
A record for Lower Street tiles and repairs
The Lower Street description in the draft includes timber and brick buildings with first-floor tile hanging at some properties. The local material description does not establish the fabric behind the surface at this house.
Distinguish decoration, replacement hanging tiles and work to the underlying wall. Evidence of one type of work should not be expanded into a record of another merely because the finished surface looks consistent.
Take a wider picture showing the particular wall and the corner where it joins the next face, followed by detail images of any previous repair or visible mark in the affected area. A change from brick to hanging tiles is a useful reference on the elevation. State which face could be seen from the street and which required a key or an agreed visit to the adjoining rear plot. Note inaccessible sections; a bright photograph taken from another garden in the past does not prove that access was available at the schedule date.
Where photographs show a rear wall or roof, mark the viewpoint and the component concerned. A view obtained from another plot should not be presented as an available inspection route without confirmation.
The status of the address and the design
The council's Historic Environment Information document, which the policies cite as a 2016 publication, lists Shere among the areas where Article 4 Directions have been confirmed; where a direction is in place, it adds controls on works fronting a highway or open space and on removing or altering chimneys, so ask the council whether one covers the address.
Consult Guildford Borough Council on the particular proposal and current direction, keeping its mapped frontage and work categories with the decision. Building regulations approval, private property permissions and the party wall process have their own requirements. If changes required for planning or heritage reasons alter a beam support, chimney or excavation footprint, give the surveyor the updated construction issue. Neither a neighbour's response nor an award replaces the council's consent.
If a notice reaches a neighbour by the rear entrance
If the plan shows only the house fronting the street, add your entrance, upper room or separate structure to a copy. Retain the original and the date received. Our adjoining-owner service explains the options for replying and the information to supply for a surveyor. Note any practical restrictions on inspecting the slope or side of the house.
Shere, Surrey party wall questions
Will an old tile-hanging invoice show whether the party wall contains timber?
It may identify the surface repaired and its date. Ask whether the contractor recorded anything behind it and precisely where; do not extend a surface repair description to concealed supports.
What should a new section show beside a bank?
Plot both ground profiles, the neighbouring structure and any retaining elements, proposed depths and available evidence for the nearest foundations on the same reference level.
Why identify whether the rear building is part of a house or a separate unit?
It can change the owners and occupiers involved, the closest structure and the route available for inspection. A single street frontage gives too little information to decide those questions.