Decide which Wembley building the drawings describe
Brent’s High Street conservation area appraisal records a group of village cottages rebuilt in the 1880s with smaller mid-terrace houses and larger gabled ends. It distinguishes these from the later semi-detached houses on Wembley Hill Road, set back and up from the pavement. A drawing simply headed “Wembley rear extension” leaves out the relationship that matters. Show the neighbouring wall and any back addition on the side nearest the works. State whether the proposal cuts into existing fabric or introduces a new wall beside it.
For the wall itself, section 1 of the Party Wall etc. Act 1996 can apply to building at the line of junction. Cutting into an existing party structure to form a bearing is a different operation, considered under section 2, with the party structure notice served under section 3. For excavation, section 6 sets separate distance and depth tests. Identify each operation on the plans. The fact that one part of a project needs a notice does not establish the procedure for every other part.
A section through a Barn Hill plot
Brent’s Barn Hill design guide discusses interest in creating basements at the rear of hillside homes. For a sloping plot, take the existing levels on both sides of the proposed excavation and use a single datum. Show the existing building, the neighbouring structure and where the proposed dig reaches its greatest depth. A quotation expressed as a depth below the rear garden can be difficult to interpret when the neighbouring garden starts at a different level.
Ask the engineer to mark where information about neighbouring foundations came from. A point uncovered at one corner is useful if it has been recorded and located. Extending that measurement along the whole building requires an engineering basis. If a side passage or rear extension has changed the nearest point of a neighbouring structure, the surveyor needs the altered footprint too. Include pits, local deepening and temporary work where these affect what will actually be excavated.
On a pair of semis, a new rear room may also reach the original shared wall. Alongside the excavation section, include the plan showing whether that wall will remain, be cut into or carry a new beam. A single planning elevation of the finished extension often leaves those operations invisible. Request the connection detail before telling a neighbour that the two structures will be independent.
Access and condition in a flat or a cottage
Lawns Court provides a local example of a completely different layout. Brent’s appraisal describes six apartment blocks built in the early 1930s, with flat roofs and bands of white rendering. For work in a block, give the block name as well as the flat number. Locate the affected room against the staircase, common landing and rooms on adjacent floors. A managing agent can help identify which entrances it controls and which visits need an occupier’s arrangement.
A schedule of condition should tell a reader where to stand to see each item. In a block, record the staircase or entrance in the photograph index. In a cottage, photograph the return of the rear addition as well as its main elevation so that an existing repair can be found again. Describe what could be seen around any fitted cupboards or roof lining. Make clear which views were unavailable and whether a supplementary visit was subsequently agreed.
Where a resident reports that a mark has become more prominent, ask for the date and any earlier photographs. Keep the resident’s account separate from observations made at the inspection. The schedule records condition before the relevant work. Deciding what caused a later change can require further measurements, drawings or specialist evidence.
Permissions and instructions at the design stage
Brent’s Local Plan describes redevelopment east of Empire Way and the distinct suburban housing around Barn Hill. Identify the building in correspondence rather than relying on a Wembley Park address to describe its construction. Use the council’s actual planning file for the premises. If they fall inside a conservation area, check the current controls for the particular work, and include any relevant consent or conditions in the design file.
Planning permission, building control and permission from a landlord are separate from the party wall award. Record what each process has considered. If a designer changes the foundation solution after a planning decision, the decision may still relate to the appearance and dimensions of the finished room while the excavation near the neighbour is materially different. Give the revised structural information to the appointed surveyor before the change reaches site.
For the adjoining owner on a sloping site
A Wembley neighbour receiving a basement notice should be able to identify their own building on the plans. Keep everything served, note the date received and mark any missing addition or level change on a separate copy. Our party wall advice for adjoining owners explains response options and how the surveyor approaches a condition record. Tell the surveyor if the ground beside the work can only be reached from another property or through an occupied flat.
Wembley party wall questions
Is the party wall question different at the end of the cottage terrace?
It can be. An end house may have an exposed side return, while another wall still separates it from the next home. Show which side the work affects, the wall position and the extent of any excavation.
Do we need the block plan for a small alteration inside a Lawns Court flat?
If the work concerns a separating floor, structural wall or common area, a block or floor plan can show relationships that the flat’s plan omits. Ask the designer and managing agent to identify the affected part.
What if the neighbour’s ground level changes along the proposed trench?
Put the changes on the section and add further sections where the nearest structure or excavation depth changes. Give the surveyor enough information to assess the different parts of the trench individually.