The short answer
Condensation is moisture from indoor air settling on a surface colder than the air, and mould grows where that surface stays wet. Look for it in cold corners, behind furniture, around windows and in bathrooms, especially in cold weather. Damp that follows the rain, leaves tide marks or brings out salts points instead to water from outside, the ground or a leak. Clean the mould safely, ventilate, heat evenly and keep notes. If it keeps returning or the cause is unclear, a surveyor can test which it is.
Is it condensation or damp? Reading the signs
Ask two questions first: where is the mould, and when does it get worse? Condensation is moisture from the indoor air turning back into water on a cold surface. Damp, as most people use the word, means water entering the building fabric from rain, the ground or a leaking pipe.
Condensation mould usually shows as black or grey speckling in the coldest spots: corners where an outside wall meets the ceiling, behind wardrobes and sofas, on window reveals, in north-facing rooms and in bathrooms and kitchens. It follows the heating and the household more than the weather, so it is often worse in winter, after showers and cooking, when washing dries indoors or when a room is left cold.
Other signs point elsewhere. A brown stain with a hard outline, called a tide mark, crumbling plaster near the floor or white fluffy crystals known as salts suggest water moving through the masonry. Condensation is close to pure water, so it seldom leaves salts. Staining that grows after wet weather, or lies below a gutter or sill, needs the outside of the building checked.
The two can overlap: a wall kept wet from outside runs colder, so mould may grow on it too. Our damp symptom checker suggests likely causes from what you can see, and the library page on condensation and mould explains the pattern.
Why condensation forms
Warm air can hold more water vapour than cold air. When moist air from cooking, washing or breathing touches a cold surface, some of that vapour turns back to liquid; the temperature where this starts is called the dew point. A surface that stays below it stays damp, and mould spores drifting in the air settle and grow.
It comes down to how much moisture the home makes, how much is removed and how cold the surfaces are. Common contributors include:
- Cold bridges: lintels, concrete frames and floor edges in some flats, and window reveals left uninsulated, which lose heat faster than the wall around them.
- Trickle vents shut or painted over, and windows that are never opened.
- Extract fans that are missing, broken, clogged or switched off because of the noise.
- Clothes dried on radiators, long showers and pans boiled without lids.
- Under-heating, or heating in short bursts, so walls never warm through.
What to do now
These steps help whatever the cause, and they build a record worth showing a surveyor or landlord.
- Clean mould safely: gloves, eye protection and a suitable mask, a window open, the product instructions followed and cleaning products never mixed. Wipe rather than dry-brush, which spreads spores.
- Keep extract fans working: run them during and after showers and cooking, clean the grilles and report weak or broken fans.
- Open the trickle vents, the slotted vents in many window frames, and leave them open in winter too.
- Keep furniture slightly off cold outside walls so air reaches behind it.
- Heat more evenly: a steady, moderate temperature usually keeps walls warmer than short blasts in one room.
- Dry washing outdoors or in a vented dryer where you can.
- Note where and when it appears: dated photos, rooms, the weather and whether the heating was on.
- If you rent, tell your landlord or managing agent in writing and send the photos.
When a survey helps
Simple changes often reduce condensation but do nothing about water coming in from outside. Consider an independent investigation when:
- mould keeps returning after cleaning and the steps above
- mould sits alongside tide marks, salts, wet or soft plaster, or decaying skirting boards
- the pattern tracks the rain as well as the heating, or more than one cause is suspected
- a tenant has complained, or landlord and tenant disagree about what is causing it
- someone is selling a damp-proof course or tanking for what may simply be condensation
What the survey checks
Savas Bulduk BSc (Hons) MRICS, Director & Chartered Building Surveyor, our Director and a Chartered Building Surveyor, visits in person for each damp, leak and defect survey and writes the report himself. HCS is independent and sells no damp treatments. Tools are matched to the question. Where condensation is suspected, he may compare the air's humidity with the temperature of walls and ceilings to see whether water can form on them, and scan rooms with a thermal camera, which shows up cold spots and cold bridges. Moisture meter results are interpreted with the construction in mind: a high number does not by itself reveal where water came from, and salts can inflate it.
He also checks for leaks and rain getting in, from gutters, downpipes, pointing, render, roofs, sills and nearby plumbing, and whether fans and vents are fitted and working. Expect the written-up findings within 3 working days of the inspection. They cover each problem area with photographs, the probable cause or causes, how sure that judgement is, what remains open and how to resolve it, and which repairs come first.
One visit cannot always decide it. Condensation varies with weather, heating and how the home was used that week, and a leak that comes and goes can be dry on the day. The report may then suggest monitoring or further tests, reported separately.
For landlords and managing agents
When a tenant reports mould, wiping it off treats the symptom and leaves the source. HCS investigates tenants' damp and mould complaints and sets out the work, whether the main cause looks like condensation, a leak or water from outside. Blaming lifestyle, or repainting without checking the building, risks the growth returning. Damp and mould can affect the health of the people living with them, as government guidance for rented housing providers explains.
For social landlords, Awaab's Law sets timeframes within which social landlords must investigate and act on hazards in their homes. Our Awaab's Law hazard investigations cover that work, and the GOV.UK guidance below sets out the duties. Where landlord and tenant disagree about the cause, see our housing disrepair expert reports.
Managing agents: access to other flats, shared roofs or plant needs the owner's or agent's permission, so arrange it before the visit if the source may lie above or next door.
Questions people ask
Is black mould always caused by condensation?
No. Condensation is a frequent cause, but mould grows on any surface that stays damp, wherever the water comes from. Mould beside a leaking pipe or under a faulty gutter can look much the same. Tide marks, salts or a patch that changes with the rain suggest something more, so check first.
Will a dehumidifier stop condensation?
It can lower condensation by drawing moisture from the air, and it helps while a room dries out. It does not warm a cold wall, mend a broken fan or keep rain out. If mould returns whenever it is switched off, the underlying causes still need attention.
Can a damp-proof course fix condensation?
No. An injected damp-proof course is meant to resist moisture rising from the ground and does nothing about moisture in indoor air. Paying for injection and replastering when the problem is condensation leaves the cause untouched. If damp has already returned after treatment, this answer explains the usual reasons.
My tenant says the mould is a building fault. What should I do?
Take it seriously, reply in writing and arrange an inspection of the ventilation, heating and outside of the building, not just how the home is used. If the cause is unclear or disputed, an independent survey can set out the likely causes and the work. Social landlords should also read the GOV.UK Awaab's Law guidance.
How long does the report take, and what does it cost?
Building defect survey instructions: starting from £650 plus VAT. We confirm a fixed fee after scoping the property, access and diagnostic brief. Your copy lands within 3 working days of the inspection. Monitoring or extra tests agreed afterwards get a separate write-up. Send photos and a short description through the damp and defect survey page.
Sources
General guidance used for this page. Each source supports the general point it is cited for; it does not describe our service.
Ask about a damp, leak or defect survey
Send photographs, the address and a note of when the problem appears. We reply with the scope and a fixed fee before anything is booked.
Hampstead Chartered Surveyors & Building Consultancy
Written by the firm’s damp, leak and defect survey team and reviewed in November 2026 by Savas Bulduk BSc (Hons) MRICS, Director & Chartered Building Surveyor. Savas carries out the surveys and writes the reports. About the firm.