What happens during a damp survey?

A step-by-step walk through a careful damp survey, from the questions asked beforehand to the written report, with a checklist for preparing your home.

Damp, leak and defect surveysPublished Reviewed by Savas Bulduk BSc (Hons) MRICS, Director & Chartered Building Surveyor
Short answer

The short answer

A careful damp survey starts before the visit, with questions about where and when the damp shows and what has been tried. On site the surveyor checks the outside first, then reads the pattern of staining indoors, choosing instruments such as a moisture meter or thermal camera only where they help. No hole is drilled and no sample taken unless you agree. Rooms or roofs that cannot be reached are listed as not inspected. At HCS, the surveyor who visited writes up the findings within 3 working days of the inspection.

Before the visit: what the surveyor asks you

Diagnosis begins with history, because damp that comes and goes leaves clues one visit can miss. Expect to be asked for photographs, which rooms are affected and when the problem shows: after heavy rain, in cold spells, after showers and cooking, or all year.

The surveyor also needs to know what has been tried. Old damp treatments, replastering, roof repairs, plumbing leaks and insurance claims all change how the evidence reads; a wall injected years ago that is wet again tells its own story.

Access is agreed now too. If the cause may lie in another flat, on a shared roof, in a pavement vault or in a communal riser, the owner or managing agent must allow entry, or only your side can be described. Unsure what you are dealing with? The damp symptom checker suggests likely causes and can start an enquiry.

Outside first: how water could be getting in

Most damp in London houses comes from water getting in from outside, through failed gutters, pointing or render or high ground levels, or from condensation inside. That is why the surveyor usually starts outside, not at the stained wall.

Gutters and downpipes are checked for blockages, leaking joints and outlets spilling onto brickwork. Pointing and render are looked at for open joints, cracks and hollow patches; parapets, copings and lead flashings for gaps that let rain run behind. Paving matters too: a patio raised against the wall can bridge the damp-proof course, the barrier near the wall base meant to stop ground moisture rising. Gullies, drains, overflows and service pipes are checked for leaks. Our library page on defective rainwater goods shows typical faults.

If a roof cannot be seen safely from the ground, a drone may be flown where flight rules, the weather, permissions and safe access all allow it. Otherwise, the gap is noted.

Inside: reading the pattern of the damp

Indoors, the shape and position of the damp often say more than a number. The surveyor notes which walls are affected, how high the staining climbs, whether there is a tide mark or white salts, and whether the damp lines up with a gutter, window, chimney breast or cold corner. Timbers within reach, such as skirtings and floorboards, are examined too, because damp masonry can lead to wet rot, dry rot or woodworm.

A moisture meter is used on suspect areas and read against how the wall is built. Solid brick, lime plaster, gypsum and dry lining all respond differently, and salts can push readings up, so a strong reading by itself is no proof of rising damp. If doubt remains, a building pathology investigation using gravimetric testing gives a firmer answer than meter readings, since it measures water in a sample from the wall.

For condensation, air humidity is recorded alongside surface temperatures, showing whether a wall, ceiling or window reveal is cold enough for moisture in the room to settle on it. See our condensation and mould guide.

No instrument is used automatically

Each tool answers a specific question; none is used for show. Some visits need little more than a meter and a careful eye, others several instruments. You will be asked before anything is drilled, cut or sampled.

  • Thermal camera: where temperature differences may reveal a cold spot, missing insulation or water spreading from a hidden leak.
  • Borescope: a slim camera fed into a floor void, cavity or boxing via a gap already there, or through a small hole if you agree to one.
  • Salts tests: samples of plaster or masonry, taken only with your consent, to help separate ground moisture from other water sources.
  • Drone: for roofs, chimneys and parapets that cannot be viewed safely any other way.

What can limit the visit, and how it is recorded

A single visit may not settle the cause. Dry weather can hide a leak that runs only in wind-driven rain. On a roof survey elsewhere, in Crouch End N8, the internal stains were dry when inspected, so a roof leak that comes and goes could be neither confirmed nor ruled out, and the report said so.

Furniture, fitted kitchens and wardrobes, stored belongings, locked rooms and no safe route into a loft or onto a flat roof all limit what can be seen. In a flat, the source may be upstairs. At a listed flat in Bayswater W2, nobody could enter the flat upstairs and nothing was dripping, so where the water started could not be pinned down.

Every area that could not be reached goes into the report marked not inspected, with the reason, so you know what is still open and what access or testing would close it.

After the visit: the written report

At HCS the surveyor who inspects also writes the report: Savas Bulduk, a Chartered Building Surveyor (MRICS) and director of the firm. His finished report goes out within 3 working days of the inspection.

Inside it you will find the evidence and where it was found, the most likely origin or origins of the water with an honest note of how sure he is, anything still unresolved and the check that would resolve it, repair priorities and photographs. Monitoring, opening-up or further tests agreed afterwards are reported on separately. Legal liability, engineering design and carrying out repairs sit outside the survey.

Buying, and want the whole property assessed? A whole-property building survey may suit better. If the damp is part of a dispute with a landlord, see housing disrepair expert reports.

How to prepare for the visit

A little preparation lets the surveyor see the evidence as it really is.

  • Clear the bases of affected walls by pulling furniture and stored items back.
  • Keep heating and ventilation as normal; changing them beforehand can hide condensation or exaggerate it.
  • Do not redecorate, replaster, wipe on mould wash or have the wall treated first, as that erases the pattern.
  • Keep your photos, and jot down when the damp worsens: after rain, in cold snaps, after bathing or cooking.
  • Arrange keys and permissions for lofts, cellars, vaults, shared roofs and neighbouring flats, and tell the managing agent if shared parts are involved.
  • Have earlier reports, treatment paperwork and repair invoices ready.
  • Then book through our damp, leak and building defect surveys page.

Questions people ask

Do I need to be at home for the survey?

Someone must give access to every room, roof space and outside area agreed beforehand. Being there helps, since you can show where the damp appears and say when it gets worse. If you cannot attend, tell us who will let the surveyor in.

Will the surveyor drill holes or take samples?

Only if you agree. Most of the inspection is visual, backed by readings that need no drilling or sampling. If a borescope needs a small hole or salts tests need samples, the surveyor asks first and explains why. If you decline, the report notes what was left untested.

Can a damp survey be done in dry weather?

Yes, though a dry spell can hide a leak that appears only in heavy rain. The surveyor still traces the routes water could take and reads the staining and salts left behind. If an intermittent leak seems likely, the report says so and may suggest monitoring or a wet-weather revisit.

How much does a damp survey cost?

Building defect survey instructions: starting from £650 plus VAT. We confirm a fixed fee after scoping the property, access and diagnostic brief. Our guide to damp survey costs in London explains what shapes the scope of a visit.

Will the survey tell me which treatment to buy?

It tells you the likely cause and which repairs matter most. The cause decides the cure, so find it before paying for treatment. A chemical damp-proof course and fresh plaster cannot fix rain penetration, bridged ground levels, plumbing leaks or condensation. HCS is independent and sells no damp treatments.

Sources

General guidance used for this page. Each source supports the general point it is cited for; it does not describe our service.

Next step

Ask about a damp, leak or defect survey

Send photographs, the address and a note of when the problem appears. We reply with the scope and a fixed fee before anything is booked.

Ask a surveyor
About the author

Hampstead Chartered Surveyors & Building Consultancy

Written by the firm’s damp, leak and defect survey team and reviewed in November 2026 by Savas Bulduk BSc (Hons) MRICS, Director & Chartered Building Surveyor. Savas carries out the surveys and writes the reports. About the firm.